DTF Print to Suit Caps.
Each Print is approximately 7.6cm
DTF Prints can be pressed on any fabric using your Home Iron or Heat Press
DTF Transfer Sheets are pressed as follows.
1. Heat press at 160c for 90 seconds
2. Allow to cool for 90 seconds
3. Peel the DTF PET film to reveal the transfer.
4. Apply a DTF Finishing Sheet (baking Paper) over the transfer.
5. Heat Press again at 160c for 10 seconds to finish.
Home Iron
1. Protect surface you're ironing on with a heat mat or towel
2. Place your T-Shirt or fabric into place and iron for 5 seconds.
3. Place the DTF image transfer into position.
4. Turn off your steam function, empty water from iron. Set the iron to cotton 130-150c
5. Iron with firm pressure for 10-15 seconds.
6. Wait until the transfer is cool and slowly peel off the clear film.
7. If the transfer is not fully adhered then please repeat step 5.
6. Congratulations your transfer is now complete.
